Valve Electric Actuator 1770 in.lbs (200Nm), 12 or 24 VDC, EPS Positioner

Description

Valve Electric Actuator 1770 in.lbs (200Nm), 12 or 24 VDC, EPS Positioner. Condition is "Seller refurbished".
Electric Actuator Standard Features
EPS-Electronic Positioning System
Quarter turn operation with mechanical limits
Rugged Type 4X weatherproof aluminum alloy enclosure
Visual valve position indicator
Manual override
Heavy duty motor with overload protection
Thermostatic anti-condensation heater
Self-locking all metal gear drive, no additional brake required
Standard ISO5211 multi-flange valve mounting
CSA Listed per UL429 and CSA C22.2 standards, CE mark
Valworx 561877A electric actuator with EPS- Electronic Positioning System is controlled by a 4-20mA input control signal. Changing the input control signal results in a corresponding and proportional change in the position of the actuator output drive.
The EPS system is self-calibrating which virtually eliminates "hunting" and provides an output position monitoring signal as standard. The positioning module is fully potted to help protect the electronics from vibration and moisture. Actuator will remain in the last known position with loss of electric power. With main power on and a loss of control signal, actuator can be set to fail closed, fail open or fail in place.
These rugged electric actuators are typically used to automate quarter turn ball valves, butterfly valves or dampers. The actuator is easy to install with international standard ISO5211 multi-flange mounting and a double square output drive. Unique integral motor/housing design provides higher torque in a very small package. Actuators are tested to rigorous UL and CSA standards and certified by CSA. Anti-condensation heater is standard and will help protect actuator against damage caused by condensation.
Type
EPS Positioner
Working Rotation
90° (quarter turn)
Max Torque
1770 in lbs (200Nm)
Voltage
24 VDC
Current Rating
1.70A @ 24VDC (full load amps)
Input Control Signal
4-20mA
Cycle Time
30 seconds per 90° rotation (no load)
Duty Cycle
70%
Enclosure
Aluminum alloy, polyester painted, SS fasteners
Enclosure Protection
Type 4X (IP67) weatherproof
Manual Override
6mm hex drive with protective cover
Motor Protection
Current overload
Temperature Range
-22 to 140 °F (-30 to +60 °C)
Valve Position Confirmation
4-20mA output monitoring signal (same type as input signal)
Anti-Condensation Heater
4 watts thermostatically controlled
ISO5211 Mounting
F07, F10 (multi-flange)
Output Drive
22mm double square (female)
Electrical Connections
Terminal strip, 1/2" NPT conduit (optional)